Gemalto CINTERION BGS2T - 8.5 AT+CREG Network Registration Status

BGS2T AT Command Set
8.5 AT+CREG
BGS2T_ATC_V01.301 Page 184 of 554 1/31/12
c
8.5 AT+CREG Network Registration Status
AT+CREG serves to monitor the BGS2T's network registration status. For this purpose the read command or URC
presentation mode are available.
Syntax
Unsolicited Result Codes
URC 1
If <urcMode>=1 and there is a change in the ME's network registration status:
+CREG: <regStatus>
URC 2
If <urcMode>=2 and there is a change of the ME's network registration status or the currently used network
cell:
+CREG: <regStatus>[, <netLac>, <netCellId>]
Parameter Description
[0]
(&F)
Disable +CREG URC.
1 Enable URC +CREG:<regStatus> to report status of network registration.
2 Enable URC +CREG:<regStatus>[,<netLac>,<netCellId>] to report
status of network registration including location information. Optional parame-
ters <netLac> and <netCellId> will not be updated during calls.
Test Command
AT+CREG=?
Response(s)
+CREG: (list of supported<urcMode>s)
OK
Read Command
AT+CREG?
Response(s)
+CREG: <urcMode>, <regStatus>[, <netLac>, <netCellId>]
OK
ERROR
+CME ERROR: <err>
Write Command
AT+CREG=[<urcMode>]
Response(s)
OK
ERROR
+CME ERROR: <err>
PIN ASC0 MUX1 MUX2 MUX3  Last Reference(s)
- + + + + - - 3GPP TS 27.007 [35]
<urcMode>
(num)(&W)(&V)
Confidential / Released