BGS2T AT Command Set
3.5 ATS18
BGS2T_ATC_V01.301 Page 90 of 554 1/31/12
c
3.5 ATS18 Extended call release report
ATS18 controls the presentation of extended call release reports for circuit switched fax and data calls. Extended
call release reports related to voice calls are controlled via AT+CEER.
The call release report is presented in numeric format and shows as follows:
If enabled the message will be reported every time a fax or data call is released or fails to be established.
Syntax
Parameter Description
An odd number enables the presentation of the extended call release report. Any even number disables this
feature.
0
(&F)
...255
Location ID as number code, see also <locationID> of AT+CEER.
Location IDs are listed in Section 3.4.1, Cause Location ID for the extended error report. Each ID is related to
another table that contains a list of <reason>s.
Reason for last call release as number code (see also <reason> of AT+CEER).
<reason> numbers and the associated descriptions are listed in several tables, sorted by different categories
at AT+CEER. The tables can be found proceeding from the Location IDs listed in Section 3.4.1, Cause Location
ID for the extended error report.
+CAUSE:
<locationID>
:
<reason>
Read Command
ATS18?
Response(s)
<n>
OK
Write Command
ATS18=<n>
Response(s)
OK
ERROR
PIN ASC0 MUX1 MUX2 MUX3 Last Reference(s)
- + + - - - - V.250
<n>
(num)(&W)(&V)
<locationID>
(num)
<reason>
(num)
To Next Page
Loading...
Need help?
General
