Gemalto CINTERION BGS2T - 8.4 AT^SRPN Replace Operator Names

BGS2T AT Command Set
8.4 AT^SRPN
BGS2T_ATC_V01.301 Page 182 of 554 1/31/12
c
8.4 AT^SRPN Replace Operator Names
AT^SRPN can be used to add or modify entries of the operator list. Changes will be effective for commands like
AT^SPLM, AT^SIND (EONS), AT^SOPS, AT+COPS or AT+COPN.
The read command returns only the changed entries of the operator list. The write command allows to add a new
operator with short and long name, to set the short and long name for a given operator or to restore the original
operator names (delete the changed names). Changes are non-volatile and effective immediately.
Syntax
Parameter Description
0 Restore the original short and long names of the specified operator or delete
an operator previously added with AT^SRPN.
The parameter <operator> is mandatory, parameters <updtShortName>
and <updtLongName> are ignored.
1 Set short and long operator names for the specified operator. Creates a new
entry if the specified operator was not yet listed. The parameters <operator>,
<updtShortName> and <updtLongName> are mandatory. Changes are
non-volatile.
The GSM Location Area Identification (LAI) number, which consists of the 3-digit Mobile Country Code (MCC)
plus the 2- or 3-digit Mobile Network Code (MNC).
Test Command
AT^SRPN=?
Response(s)
^SRPN:(<maxEntries>), (<usedEntries>)
OK
Read Command
AT^SRPN?
Response(s)
[^SRPN: <operator>, <origShortName>, <origLongName>, <updtShortName>, <updtLongName>]
[^SRPN: ...]
OK
ERROR
+CME ERROR: <err>
Write Command
AT^SRPN=<mode>, <operator>[, <updtShortName>, <updtLongName>]
Response(s)
OK
ERROR
+CME ERROR: <err>
PIN ASC0 MUX1 MUX2 MUX3  Last
- + + + + - -
<mode>
(num)
<operator>
(str)
Confidential / Released