Gemalto CINTERION BGS2T - HTTP POST (Polling Mode)

BGS2T AT Command Set
10.13 Examples of how to Configure and Use Internet Service Profiles
BGS2T_ATC_V01.301 Page 292 of 554 1/31/12
c
10.13.14 HTTP POST (Polling Mode)
^SISR: 1,578 Command response indicates that 578 bytes are
available for reading.
Return-Path: <subscriber1@testdomain.com>
X-Original-To: subscriber1@testdomain.com
Delivered-To: subscriber2@testdomain.com
Received: from 10.10.0.132 (unknown [10.10.0.132])
by testdomain.com (Postfix) with SMTP id 379321D004
for <subscriber1@testdomain.com>; Tue, 20 Dec 2005 08:00:07 +0100 (CET)
To: subscriber2@testdomain.com
Cc:
From: subscriber1@testdomain.com
Subject: TestMail
Message-Id: <20051220070007.379321D004@testdomain.com >
Date: Tue, 20 Dec 2005 08:00:07 +0100 (CET)
X-UIDL: &lL"!(Z6"!^cl!!1+%"!
Status: RO
Hallo Tom!Bye Bye Tom!
. Dot indicates end of mail according to RFC 2821.
OK
at^sisr=1,1000 Try to read 1000 bytes once again.
^SISR: 1,-2 No more data available to read, i.e. the service has
finished.
OK
at^sisi=1 Check the connection state of service profile 1.
^SISI: 1,6,578,0,0,0 The command response indicates that the POP3
service is in state "6" (Down) and that 578 bytes have
been retrieved.
OK
at^sise=1 Check error status of service profile 1.
^SISE: 1,0 The command response confirms that no error
occurred.
OK
at^sisc=1 Close the service.
OK
at^siss=1,srvType,"Http" Select service type HTTP.
OK
at^siss=1,conId,1 Select connection profile 1.
OK
at^siss=1,hcMethod,1 Select "Post" method.
OK
at^siss=1,address,"http://192.168.1.3/datafiles/dummy/dummy.txt"
OK
at^siss=1,hcContLen,180 Try to upload 180 bytes.
OK
at^siso=1 Open the service.
OK
at^sisw=1,100 Send the first 100 bytes.
^SISW: 1,100,0
OK
at^sisw=1,100 Try to send again 100 bytes.
^SISW: 1,80,0 80 bytes are sent.
OK
at^sisw=1,40 Try to write data once again.
Confidential / Released