BGS2T AT Command Set
3. Status Control Commands
BGS2T_ATC_V01.301 Page 64 of 554 1/31/12
c
3. Status Control Commands
The AT Commands described in this chapter allow the external application to obtain various status information
from the BGS2T.
3.1 AT+CMER Common Event Reporting Configuration
AT+CMER controls details of the "+CIEV" URC presentation related to AT^SIND and AT+CIND. If registered via
those commands the URCs are sent whenever a value of the related indicator changes.
In addition, AT+CMER controls "^SLCC" URCs related to AT^SLCC. For details refer to Call Status Infor-
mation, AT^SLCC and AT^SCFG, parameter <sucs>.
The read command returns the URC presentation mode <mode> and among others, the indicator event reporting
status <ind>.
The write command enables and disables the presentation of "+CIEV: <indDescr>, <indValue>
1
[, <ind-
Value>
2
]" URCs. <indDescr> refers to the name of a "+CIEV" indicator and <indValue> is the new value of
this indicator.
After AT+CMER has been switched on, initial URCs for all registered indicators will be issued. See examples pro-
vided in Section 3.2, AT+CIND and Section 3.3, AT^SIND.
AT+CNMI is a similar command to control SMS related URCs.
Syntax
Unsolicited Result Code
+CIEV: <indDescr>, <indValue>
1
[, <indValue>
2
]
A value of an indicator has changed.
Test Command
AT+CMER=?
Response(s)
+CMER: (list of supported<mode>s), (list of supported <keyp>s), (list of supported <disp>s), (list of
supported <ind>s), (list of supported <bfr>s)
OK
Read Command
AT+CMER?
Response(s)
+CMER: <mode>, <keyp>, <disp>, <ind>, <bfr>
OK
Write Command
AT+CMER=[<mode>[, <keyp>[, <disp>[, <ind>[, <bfr>]]]]]
Response(s)
OK
ERROR
+CME ERROR: <err>
PIN ASC0 MUX1 MUX2 MUX3 Last Reference(s)
- + + + + - - 3GPP TS 27.007 [35]
To Next Page
Loading...
Need help?
General
