BGS2T AT Command Set
8.11 AT^SMONG
BGS2T_ATC_V01.301 Page 199 of 554 1/31/12
c
Note
• For compatibility with earlier products and to support legacy applications, often any input character will stop
the periodic output of the write command. But since this applies only in certain cases (depending on the set-
tings of AT+IPR and AT+CMUX), it is recommended to always use "at" or "AT".
8.11.1 AT^SMONG Cell Info Table
Example output for AT^SMONG:
Columns of the cell info table:
GPRS Monitor
BCCH G PBCCH PAT MCC MNC NOM TA RAC # Cell #
0637 1 - 4 234 05 2 00 0B
Column Description
BCCH ARFCN of BCCH carrier.
To distinguish between identical ARFCNs in 1800MHz and 1900MHz radio bands, a "*"
attached to the channel number indicates the 1900MHz band
G GPRS status:
0 GPRS not available in currently used cell
1 GPRS available in currently used cell
2 GPRS attached
PBCCH If PBCCH is present, indication of ARFCN, else ''-'' or if Frequency Hopping is used ''H''
PAT Priority Access Threshold (3GPP TS 24.008 [32] 10.5.2.37b)
0 Packet access is not allowed in the cell
1 Spare, shall be interpreted as "000" (packet access not allowed)
2 Spare, shall be interpreted as "000" (packet access not allowed)
3 Packet access is allowed for priority level 1
4 Packet access is allowed for priority level 1 to 2
MCC Mobile Country Code
MNC Mobile Network Code
NOM Network Operation Mode (1...3)
TA Timing Advance Value
RAC Routing Area Code (as hexadecimal value)
To Next Page
Loading...
Need help?
General
