BGS2T AT Command Set
12.25 AT+FTH
BGS2T_ATC_V01.301 Page 365 of 554 1/31/12
c
12.25 AT+FTH Transmit Data Using HDLC Framing
The AT+FTH command causes the TA to transmit data using the HDLC protocol and the modulation schemes
defined in Section 12.1, FAX parameters. An ERROR response code results if the command is issued while the
modem is on-hook. The test command can be used in off-hook mode to check the modulation schemes sup-
ported by BGS2T.
Syntax
Note
• Used for Fax Class 1 only
Test Command
AT+FTH=?
Response(s)
In off-hook mode only:
+FTH:(list of <mod>s)
OK
In on-hook mode:
ERROR
Write Command
AT+FTH=<mod>
Response(s)
CONNECT
PIN ASC0 MUX1 MUX2 MUX3 Last Reference(s)
- + + - - - - TIA/EIA-578
To Next Page
Loading...
Need help?
General
