Gemalto CINTERION BGS2T - 15.23 AT^SSTR SAT Response

BGS2T AT Command Set
15.23 AT^SSTR
BGS2T_ATC_V01.301 Page 456 of 554 1/31/12
c
15.23 AT^SSTR SAT Response
The TE is expected to acknowledge the AT^SSTGI response with AT^SSTR to confirm that the Proactive Com-
mand has been executed. AT^SSTR will also provide any user information, e.g. a selected menu item.
Syntax
Parameter Description
BGS2T Remote-SAT interface states
0 RESET
1 OFF
2IDLE
3 PAC
4WAIT
Number related to Proactive Command or event type according to 3GPP TS 11.14 [15].
0 The proactive command has been successfully finished.
1...255 The proactive command did not perform successfully.
This text has to be shown to the user for an appropriate time, e.g. 2 seconds. The text contains information
regarding the termination cause, e.g. in case of a failed dialing process call barring through Call Control by SIM
mechanism may be indicated.
If <TerminationCauseText> is an empty string and <TerminationQualifier> is not equal to 0, the TE
may give an own indication to the user.
Test Command
AT^SSTR=?
Response(s)
^SSTR:(list of supported <state>s), (list of supported <cmdType>s)
OK
Read Command
AT^SSTR?
Response(s)
^SSTR: <state>, <cmdType>
OK
Write Command
AT^SSTR=<cmdType>, <status>[, <inputNumber>][, <inputString>][, <statAddInfo>]
Response(s)
^SSTR: <cmdType>[, <TerminationQualifier>, <TerminationCauseText>]
OK
PIN ASC0 MUX1 MUX2 MUX3  Last
- + + + + - -
<state>
(num)
<cmdType>
(num)
<TerminationQualifier>
(num)
<TerminationCauseText>
(str)
Confidential / Released