Gemalto CINTERION BGS2T - 10.7 AT^SISC Internet Service Close

BGS2T AT Command Set
10.7 AT^SISC
BGS2T_ATC_V01.301 Page 269 of 554 1/31/12
c
10.7 AT^SISC Internet Service Close
The AT^SISC write command closes the TCP/IP connection to the remote peer which was opened with
AT^SISO. All resources are released, all status information parameters, e.g. <srvState>, <unackData>,
<ackData>, <rxCount> and <txCount> counters, are reset. Only the initial configuration settings are pre-
served. The service can be restarted any time, using the same configuration or a new one.
Syntax
Parameter Description
0...9 <srvProfileId> specified with AT^SISS.
Test Command
AT^SISC=?
Response(s)
OK
Write Command
AT^SISC=<srvProfileId>
Response(s)
OK
ERROR
+CME ERROR: <err>
PIN ASC0 MUX1 MUX2 MUX3  Last
± + + + + - -
<srvProfileId>
(num)
Confidential / Released