BGS2T AT Command Set
10.6 AT^SISO
BGS2T_ATC_V01.301 Page 264 of 554 1/31/12
c
Syntax
Parameter Description
<srvProfileId> 0 ... 9 specified with AT^SISS.
Internet service state.
Please note, that the state of an Internet service may influence the state of the serial DCD line. For details see
description of value 2 for parameter <value> of command AT&C.
2 Allocated
Service profile resources are allocated, i.e. at least the service type has been
set (parameter <srvParmTag>, value "srvType" of AT^SISS). The service is
not opened, but ready for configuration.
3 Connecting
State after opening a service with AT^SISO where the connection is being
established.
If connection setup is successful the service proceeds to the state "4" (Up) and
one of the URCs "^SISW" and "^SISR" may follow. If connection setup is not
successful, the "^SIS" URC may appear and the service enters <srvState>
6 (Down).
In the case of FTP, <srvState>=3 means that the command channel is being
established.
If the service profile is configured as Socket listener, then the listener always
stays at <srvState>=3 and <socketState>=3 (LISTENER), while the
<srvState> and <socketState> of the dynamically assigned service pro-
file may change. See examples in Section 10.6.1.
Test Command
AT^SISO=?
Response(s)
OK
Read Command
AT^SISO?
Response(s)
^SISO: <srvProfileId>, <srvParmTag>value "srvType" [, <srvState>, <socketState>,
<rxCount>, <txCount>, <locAddr>, <remAddr>]
[^SISO: ...]
OK
Write Command
AT^SISO=<srvProfileId>
Response(s)
OK
ERROR
+CME ERROR: <err>
PIN ASC0 MUX1 MUX2 MUX3 Last
± + + + + - -
<srvProfileId>
(num)
<srvState>
(num)
To Next Page
Loading...
