BGS2T AT Command Set
15.37 AT^SSTR
BGS2T_ATC_V01.301 Page 473 of 554 1/31/12
c
15.37 AT^SSTR SAT Response - Setup Menu (37)
The TE is expected to acknowledge the AT^SSTGI response with AT^SSTR to confirm that the Proactive Com-
mand has been executed.
Syntax
Parameter Description
0...255
0 Command performed successfully. Indicate that the user has accepted the call
request.
4 Command performed successfully, but requested icon could not be displayed.
32 ME currently unable to process command
48 Command beyond ME's capabilities
132 ME currently unable to process command because screen is busy
Optional additional command status; for possible values refer to 3GPP TS 11.14 [15].
0...255
Note
• The response simply conveys, to the SAT, the information that the main menu was received and set up on
the user interface. It does not transmit any information about a selected item, like in the case of AT^SSTR.
Once this command was executed the user can proceed as described in the AT^SSTR SAT Response - Setup
Menu (37).
Write Command
AT^SSTR=37, <status>, , [, <statAddInfo>]
Response(s)
OK
PIN ASC0 MUX1 MUX2 MUX3 Last
- + + + + - -
<status>
(num)
<statAddInfo>
(num)
To Next Page
Loading...
Need help?
General
