BGS2T AT Command Set
11.9 AT+CGEREP
BGS2T_ATC_V01.301 Page 316 of 554 1/31/12
c
11.9 AT+CGEREP GPRS event reporting
The write command enables or disables sending of unsolicited result codes, "+CGEV" from MT to TE in the case
of certain events occurring in the GPRS MT or the network. <mode> controls the processing of unsolicited result
codes specified within this command. <bfr> controls the effect on buffered codes when <mode> 1 or 2 is
entered. If a setting is not supported by the MT, ERROR or +CME ERROR: is returned.
Read command returns the current <mode> and buffer settings.
Test command returns the modes and buffer settings supported by the MT as compound values.
Syntax
Unsolicited Result Codes
URC 1
+CGEV: REJECT <PDP_type>, <PDP_addr>
A network request for PDP context activation occurred when the MT was unable to report it to the TE with a
+CRING unsolicited result code and was automatically rejected.
URC 2
+CGEV: NW REACT <PDP_type>, <PDP_addr>, [<cid>]
The network has requested a context reactivation. The <cid> that was used to reactivate the context is pro-
vided if known to the MT.
URC 3
+CGEV: NW DEACT <PDP_type>, <PDP_addr>, [<cid>]
The network has forced a context deactivation. The <cid> that was used to activate the context is provided
if known to the MT.
URC 4
+CGEV: ME DEACT <PDP_type>, <PDP_addr>, [<cid>]
The mobile equipment has forced a context deactivation. The <cid> that was used to activate the context is
provided if known to the MT.
Test Command
AT+CGEREP=?
Response(s)
+CGEREP: (list of supported <mode>s), (list of supported <bfr>s)
OK
Read Command
AT+CGEREP?
Response(s)
+CGEREP: <mode>, <bfr>
OK
Write Command
AT+CGEREP=[<mode>[, <bfr>]]
Response(s)
OK
ERROR
+CME ERROR: <err>
PIN ASC0 MUX1 MUX2 MUX3 Last Reference(s)
+ + + + + - - 3GPP TS 27.007 [35]
To Next Page
Loading...
Need help?
General
