BGS2T AT Command Set
11.8 AT+CGEQREQ
BGS2T_ATC_V01.301 Page 315 of 554 1/31/12
c
This parameter indicates the targeted time between request to transfer an SDU at one SAP to its delivery at the
other SAP, in milliseconds.
[0] subscribed value
10...150 (value needs to be divisible by 10 without remainder)
200...950 (value needs to be divisible by 50 without remainder)
1000...4000 (value needs to be divisible by 100 without remainder)
This parameter specifies the relative importance for handling of all SDUs belonging to the UMTS bearer com-
pared to the SDUs of the other bearers.
[0] subscribed
1
2
3
Packet Data Protocol Type
“IP“
Notes
• If parameters are not defined, the parameter default values depend on the HLR-stored subscribed default val-
ues.
• Definitions of parameters can be found in 3GPP TS 23.107 [30].
• If QOS settings are configured with AT+CGQREQ and AT+CGEQREQ in parallel the MT will use only the
AT+CGEQREQ settings for connection setup while the AT+CGQREQ settings are ignored.
<Transfer delay>
(num)
<Traffic handling priority>
(num)
<PDP_type>
(str)
To Next Page
Loading...
Need help?
General
