BGS2T AT Command Set
7.11 AT^SHUP
BGS2T_ATC_V01.301 Page 150 of 554 1/31/12
c
7.11 AT^SHUP Hang up call(s) indicating a specific 3GPP TS 24.008
release cause
The AT^SHUP write command terminates calls known to the ME and indicates a specific 3GPP TS 24.008 [32]
release cause specified by the user. The command can be used for voice, Fax and data calls. Calls will be ter-
minated regardless of their current call status, which may be any of the states listed with AT+CLCC.
Syntax
Parameter Description
Release cause
3GPP TS 24.008 [32] release cause to be indicated to the network.
The BGS2T will release the selected connection(s) with release cause indication "cause" and location "user" (0)
in the "disconnect" protocol message to the network. It depends on the network whether or not the release cause
will be forwarded to the remote party.
1 Send 3GPP TS 24.008 [32] release cause "unassigned (unallocated) number"
16 Send 3GPP TS 24.008 [32] release cause "normal call clearing "
17 Send 3GPP TS 24.008 [32] release cause "user busy "
18 Send 3GPP TS 24.008 [32] release cause "no user responding "
27 Send 3GPP TS 24.008 [32] release cause "destination out of order "
31 Send 3GPP TS 24.008 [32] release cause "normal, unspecified"
Call number
The "call number" is an optional index used in the list of current calls indicated by AT+CLCC. The AT^SHUP com-
mand will terminate the call identified by the given call number. The default call number "0" is not assigned to
any call, but signifies "all calls". As "0" is the default value, it may be omitted.
[0] Terminate all known calls.
1...7 Terminate the specific call number <cn>.
Test Command
AT^SHUP=?
Response(s)
OK
Write Command
AT^SHUP=<cause>[, <cn>]
Response(s)
OK
ERROR
PIN ASC0 MUX1 MUX2 MUX3 Last
+ + + + + - -
<cause>
(num)
<cn>
(num)
To Next Page
Loading...
Need help?
General
