Gemalto CINTERION BGS2T - 15.21 AT^SSTGI SAT Get Information - Set up Idle Mode Text (40)

BGS2T AT Command Set
15.21 AT^SSTGI
BGS2T_ATC_V01.301 Page 454 of 554 1/31/12
c
15.21 AT^SSTGI SAT Get Information - Set up Idle Mode Text (40)
This command shall be used after receiving the URC ^SSTN: 40.
It provides text and optionally an icon to be displayed by the TE when the display is Idle.
Syntax
Parameter Description
40 Proactive command ID, see Remote-SAT Command Types
This byte is RFU.
Text to be displayed when TE in IDLE mode
0...255 Used as bit field
bit 1 0: Icon is self explanatory and replaces text
1: Icon is not self-explanatory and shall be displayed with the text Determined
value only if associated icon ID is not 0 (an icon exists).
bit 2-8 RFU
0...255
0No Icon
Note
• AT^SSTGI can be issued during states IDLE, PAC and WAIT for this proactive command without previously
receiving a URC ^SSTN:<cmdType>, see AT^SSTGI.
Write Command
AT^SSTGI=40
Response(s)
^SSTGI: <cmdType>, <commandDetails>, <text>, <iconQualifier>, <iconId>
OK
ERROR
+CME ERROR: <err>
PIN ASC0 MUX1 MUX2 MUX3  Last
- + + + + - -
<cmdType>
(num)
<commandDetails>
(num)
<text>
(str)
<iconQualifier>
(num)
<iconId>
(num)
Confidential / Released