Gemalto CINTERION BGS2T - 12.4 AT+FBOR Query data Bit Order

BGS2T AT Command Set
12.4 AT+FBOR
BGS2T_ATC_V01.301 Page 344 of 554 1/31/12
c
12.4 AT+FBOR Query data Bit Order
This command queries the bit order for the receive mode. The mode is set by the ME depending on the selected
Service Class, see "AT+FCLASS Fax: Select, read or test service class".
Syntax
Parameter Description
bit order modes
0 Direct bit order for both Phase C and for Phase B/D data.
[1] Reversed bit order for Phase C data, direct Bit Order for Phase B/D data.
Note
• Used for Fax Class 2 only.
Test Command
AT+FBOR=?
Response(s)
(list of supported <bor>s)
OK
Read Command
AT+FBOR?
Response(s)
<bor>
OK
Write Command
AT+FBOR=<bor>
Response(s)
OK
PIN ASC0 MUX1 MUX2 MUX3  Last Reference(s)
- + + - - - - EIA PN-2388
<bor>
(num)
Confidential / Released