Gemalto CINTERION BGS2T - 11.16 AT^SGCONF Configuration of GPRS related Parameters

BGS2T AT Command Set
11.16 AT^SGCONF
BGS2T_ATC_V01.301 Page 330 of 554 1/31/12
c
11.16 AT^SGCONF Configuration of GPRS related Parameters
Syntax
Parameter Description
The maximum number of octets in an information field of Unnumbered (U) frames.
0 No negotiation with network (500 will be used).
140...1520
(P)
Lower values diminish performance.
GPRS Multislot Class. The value can be one of the classes indicated with the Test command. The value set is
volatile and powerup value is the maximum allowed.
Note
• AT^SGCONF will respond with "+CME ERROR: operation temporary not allowed" if the module is already
GPRS attached (see AT+CGATT).
Test Command
AT^SGCONF=?
Response(s)
^SGCONF: (list of supported <llc_pdu_length_U>s), (list of supported <GPRS msclass>es)
OK
Read Command
AT^SGCONF?
Response(s)
^SGCONF: <llc_pdu_length_U>, <GPRS msclass>
OK
Write Command
AT^SGCONF=[<llc_pdu_length_U>][, [<GPRS msclass>]]
Response(s)
OK
ERROR
+CME ERROR: <err>
PIN ASC0 MUX1 MUX2 MUX3  Last
- + + + + - -
<llc_pdu_length_U>
(num)
<GPRS msclass>
(num)
Confidential / Released