BGS2T AT Command Set
15.2 Remote-SAT States
BGS2T_ATC_V01.301 Page 423 of 554 1/31/12
c
15.2.2 Remote-SAT State Transition Table
The following table outlines which AT commands can be issued during certain states. However, the test and read
AT commands are available at any time. This way it is possible to determine the current state of the interface via
AT^SSTA?.
Meaning of options usable in column "M/O/X" of the following tables:
M: The TE has to issue the AT command to get Remote-SAT service (mandatory).
O: Usage of AT command is optional.
X: Usage of AT command is not allowed or not useful at this time and may cause an error message.
Table 15.1: State: RESET description
Table 15.2: State: OFF description
Table 15.3: State: IDLE description
RESET: State after power on the ME.
AT command M/O/X Description
^SSTA=0,n O Enable AR Mode (with alphabet
type <n>)
^SSTA=1,n O Enable ER Mode (with alphabet
type <n>)
^SSTGI=<pac> X
^SSTR=<pac> X
^SSTR=<event> X
OFF: ME is in Auto Response Mode.
AT command M/O/X Description
^SSTA=0,n O Enable AR Mode (with alphabet
type <n>)
^SSTA=1,n O Enable ER Mode (with alphabet
type <n>)
^SSTGI=<pac> X
^SSTR=<pac> X
^SSTR=<event> X
IDLE: ME is in Explicit Response Mode.
AT command M/O/X Description
^SSTA=0,n O Enable AR Mode (with alphabet
type <n>)
^SSTA=1,n O Enable ER Mode (with alphabet
type <n>)
^SSTGI=<pac> O Show PAC information
^SSTR=<pac> X
^SSTR=<event> O
To Next Page
Loading...
Need help?
General
