Gemalto CINTERION BGS2T - 8.8 AT^SMOND Cell Monitoring

BGS2T AT Command Set
8.8 AT^SMOND
BGS2T_ATC_V01.301 Page 190 of 554 1/31/12
c
8.8 AT^SMOND Cell Monitoring
The AT^SMOND execute command can be used to obtain status information of the service cell and up to six neigh-
bour cells. The advantage over other cell monitoring commands is that AT^SMOND delivers more detailed infor-
mation about the received signal strength.
Syntax
Parameter Description
Serving cell information (comma-separated, no cr/lf included)
<MCC>,<MNC>,<LAC>,<cell>,<BSIC>,<chann>,<RxLev>,<RxLev>Full,<RxLev>Sub,<RxQual>,<RxQual
>Full,<RxQual>Sub,<Timeslot>
If no serving cell is found, unavailable values are omitted:" ,,,,,,<RxLev>,,,0,,,0"
Neighbour cell information for neighbour cell 1 through 6 (comma-separated, no cr/lf included)
<MCC>
1
,<MNC>
1
,<LAC>
1
,<cell>
1
,<BSIC>
1
,<chann>
1
,<RxLev>
1
, (these parameters repeated for neighbour
cells 2 through 6 with no CR/LF): ... <MCC>
6
,<MNC>
6
,<LAC>
6
,<cell>
6
,<BSIC>
6
,<chann>
6
,<RxLev>
6
An unavailable cell appears as follows: " ,,,,,,0"
Values for RSSI and BER (comma-separated, no cr/lf included)
<RSSI>,<BER>
Mobile country code
3 digits, e.g. 232
000 Not decoded
Test Command
AT^SMOND=?
Response(s)
OK
ERROR
+CME ERROR: <err>
Exec Command
AT^SMOND
Response(s)
^SMOND:[<sci>][, <nci>][, <TA>][, <rssiber>]
OK
ERROR
+CME ERROR: <err>
PIN ASC0 MUX1 MUX2 MUX3  Last Reference(s)
+ + + + + - - 3GPP TS 45.008 [39]
<sci>
(str)
<nci>
(str)
<rssiber>
(str)
<MCC>
(num)
Confidential / Released