BGS2T AT Command Set
8.8 AT^SMOND
BGS2T_ATC_V01.301 Page 192 of 554 1/31/12
c
Bit Error rate, with value 99 indicating "not known or not detectable"
0...7 as RXQUAL values RXQUAL0 to RXQUAL7 in 3GPP TS 45.008 [39] section
8.2.4
Notes
• To some extent, the cell monitoring commands AT^SMOND, AT^MONI, AT^MONP and AT^SMONC cover the
same parameters. The receiving level, for example, can be queried with all three commands. Yet the resulting
values may be slightly different, even though obtained over a time period of a few seconds. This is quite nor-
mal and nothing to worry about, as the cell information is permanently updated.
• During a connection, not all of the neighbour cell information can be decoded. The following restrictions apply:
- Information is updated only for neighbour cells that have already been visible at connection setup, and
continue to be included in the list of cells.
- New neighbour cells added to the list, for example after handover, cannot be displayed until the connection
is released.
Example
<BER>
(num)
at^smond
Execute command
^SMOND:262,01,3008,6060,32,100,66,,,0,,,0,
262,01,3008,DDD1,35,92,80,
262,01,3008,,31,96,83,
262,01,3008,BFBE,35,27,86,
262,01,3008,,32,98,88,
262,01,3008,BB44,32,90,89,
262,01,3008,8307,31,22,93,
2,23,99
Line breaks inserted for readability in print
To Next Page
Loading...
Need help?
General
