BGS2T AT Command Set
16.6 AT^SPBD
BGS2T_ATC_V01.301 Page 495 of 554 1/31/12
c
16.6 AT^SPBD Purge phonebook memory storage
AT^SPBD can be used to purge the selected phonebook <storage> manually, i.e. all entries stored in the
selected phonebook storage will be deleted. CAUTION! The operation cannot be stopped nor reversed!
The AT^SPBD test command returns the list of phonebooks which can be deleted with AT^SPBD.
An automatic purge of the phonebooks is performed when the SIM card is removed and replaced with a different
SIM card. This affects the ME based part of the "LD" storage, and storages "MC" and "RC". Storage "ME" is not
affected.
Syntax
Parameter Description
If test command: List of phonebooks which can be deleted by AT^SPBD.
If write command: Phonebook to be deleted.
For a detailed description of storages see AT+CPBS.
“LD“ Last number dialed phonebook
“MC“ Missed (unanswered received) calls list
“RC“ Received calls list
Note
• Users should be aware that when using this AT command quickly after SIM PIN authentication the SIM data
may not yet be accessible, resulting in a short delay before the requested AT command response is returned.
See Section 19.1, Restricted access to SIM data after SIM PIN authentication for further detail.
Test Command
AT^SPBD=?
Response(s)
^SPBD: (list of supported <storage>s)
OK
ERROR
+CME ERROR: <err>
Write Command
AT^SPBD=<storage>
Response(s)
OK
ERROR
+CME ERROR: <err>
PIN ASC0 MUX1 MUX2 MUX3 Last
+ + + + + - -
<storage>
(str)
To Next Page
Loading...
Need help?
General
