BGS2T AT Command Set
7.25 AT+CSNS
BGS2T_ATC_V01.301 Page 170 of 554 1/31/12
c
7.25 AT+CSNS Single Numbering Scheme
The AT+CSNS command specifies how the ME will accept incoming calls when no bearer capability information
is provided with the call, e.g. single numbering scheme calls or calls originating from analog devices.
Syntax
Parameter Description
[0]
(D)
Voice: Each call received without bearer element is assumed to be speech
2 Fax: Each call received without bearer element is assumed to be an incoming
fax.
4 Data: Each call received without bearer element is assumed to be a data call.
Please take into account that the bearer service parameters set with AT+CBST
apply to all data calls including those received without bearer capability.
Note
• The command must be set before the call comes. By default, when you do not modify the settings, all calls
received without bearer element are assumed to be voice.
Test Command
AT+CSNS=?
Response(s)
+CSNS: (list of supported<mode>s)
OK
Read Command
AT+CSNS?
Response(s)
+CSNS: <mode>
OK
Write Command
AT+CSNS=[<mode>]
Response(s)
OK
ERROR
+CME ERROR: <err>
PIN ASC0 MUX1 MUX2 MUX3 Last Reference(s)
- + + + + - - 3GPP TS 27.007 [35]
<mode>
(num)(NV)
To Next Page
Loading...
Need help?
General
