Gemalto CINTERION BGS2T - 8.12 AT^SALS Alternate Line Service

BGS2T AT Command Set
8.12 AT^SALS
BGS2T_ATC_V01.301 Page 200 of 554 1/31/12
c
8.12 AT^SALS Alternate Line Service
The AT^SALS command is designed to support Alternate Line Service. This allows the subscriber to use two
voice numbers on the same SIM card (service requires a dual line SIM card).
The write command enables or disables the presentation of <view> and specifies the <line> used for outgoing
calls. The read command returns the presentation mode of <view> and the currently selected <line>.
Syntax
Unsolicited Result Code
If switched on with <view>=1:
^SALS: <line>
Indicates the line used by an incoming call.
Parameter Description
Controls the presentation mode of the URC "^SALS" which indicates the line number used by an incoming call:
0
(&F)(P)
Disables indication of the called line
1 Enables indication of the called line
Selects the line to be used for outgoing calls. Setting is global for the ME and non volatile.
1
(&F)(D)
ALS Line 1
2 ALS Line 2
Note
• If a non ALS SIM is inserted, the <line> will be reset to line 1.
Test Command
AT^SALS=?
Response(s)
^SALS:(list of supported <view>s), (list of supported <line>s)
OK
Read Command
AT^SALS?
Response(s)
^SALS: <view>, <line>
OK
ERROR
Write Command
AT^SALS=<view>[, <line>]
Response(s)
OK
ERROR
PIN ASC0 MUX1 MUX2 MUX3  Last
+ + + + + - -
<view>
(num)
<line>
(num)
Confidential / Released