BGS2T AT Command Set
4.6 AT+ILRR
BGS2T_ATC_V01.301 Page 99 of 554 1/31/12
c
4.6 AT+ILRR Bit Rate Reporting
AT+ILRR controls whether or not the intermediate result code "+ILRR" is transmitted from the BGS2T to the TE
when a connection is being set up. The result code indicates the current bit rate. It is issued before the final result
code of the connection, e.g. CONNECT, is transmitted to the TE.
Syntax
Intermediate Result Code
+ILRR: <rate>
Indicates current bit rate setting upon connection setup.
Parameter Description
0
(&F)
Disables bit rate reporting.
1 Enables bit rate reporting.
Bit rate setting upon connection setup (bps)
0 Autobauding (see Section 4.7.1, Autobauding).
300
600
1200
2400
4800
9600
14400
Test Command
AT+ILRR=?
Response(s)
+ILRR: (list of supported <value>s)
OK
Read Command
AT+ILRR?
Response(s)
+ILRR: <value>
OK
Write Command
AT+ILRR=<value>
Response(s)
OK
ERROR
+CME ERROR: <err>
PIN ASC0 MUX1 MUX2 MUX3 Last Reference(s)
+ + + - - - - V.250
<value>
(num)(&W)(&V)
<rate>
(num)
To Next Page
Loading...
Need help?
General
