BGS2T AT Command Set
7.8 ATDL
BGS2T_ATC_V01.301 Page 147 of 554 1/31/12
c
7.8 ATDL Redial last number used
Syntax
Command Description
This command redials the last voice and data call number used in the ATD command. If terminated with semi-
colon ";" ATDL dials the last voice call number stored in the "LD" phonebook. Otherwise, the last dialed data or
fax number will be used (not contained in the "LD" phonebook).
Notes
• This command may be aborted generally by receiving a character during execution. Abortion is not possible
during some states of connection setup such as handshaking.
• Parameter "I" and "i" only if no *#-code is within the dial string.
Exec Command
ATDL[;]
Response(s)
If there is no last number or number is not valid:
+CME ERROR: <err>
If no dialtone (parameter ATX2 or ATX4):
NO DIALTONE
If busy (parameter setting ATX3 or ATX4):
BUSY
If connection cannot be set up:
NO CARRIER
NO DIALTONE
If successfully connected and non-voice call (TA switches to online data mode):
CONNECT <text>
When TA returns to command mode after call release:
OK
If successfully connected and voice call:
OK
PIN ASC0 MUX1 MUX2 MUX3 Last Reference(s)
+ + + ± ± - - V.250
To Next Page
Loading...
