Gemalto CINTERION BGS2T - 7.16 ATS10 Set disconnect delay after indicating the absence of data carrier

BGS2T AT Command Set
7.16 ATS10
BGS2T_ATC_V01.301 Page 155 of 554 1/31/12
c
7.16 ATS10 Set disconnect delay after indicating the absence of data
carrier
ATS10 determines the amount of time, that the ME remains connected in absence of a data carrier. If the data
carrier is detected before disconnect, the ME remains connected.
Syntax
Parameter Description
001...2
(&F)
...254 Number of tenths of seconds to wait before disconnecting after ME has indi-
cated the absence of received line signal
Read Command
ATS10?
Response(s)
<n>
OK
Write Command
ATS10=<n>
Response(s)
OK
ERROR
PIN ASC0 MUX1 MUX2 MUX3  Last Reference(s)
- + + - - - - V.250
<n>
(num)(&W)(&V)
Confidential / Released