BGS2T AT Command Set
18. Miscellaneous Commands
BGS2T_ATC_V01.301 Page 515 of 554 1/31/12
c
18. Miscellaneous Commands
The AT Commands described in this chapter are related to various areas.
18.1 A/ Repeat Previous Command Line
Repeat previous AT command line.
In general, after beginning a command line with character "a" or "A" a second character "t", "T" or "/" has to follow.
"/" acts as line terminating character. In case of using a wrong second character, it is necessary to start again
with character "a" or "A".
Syntax
Exec Command
A/
Response(s)
PIN ASC0 MUX1 MUX2 MUX3 Last Reference(s)
- + + + + - - V.250
To Next Page
Loading...
