BGS2T AT Command Set
10.3 AT^SIPS
BGS2T_ATC_V01.301 Page 249 of 554 1/31/12
c
10.3 AT^SIPS Internet Profile Storage
AT^SIPS saves and loads the settings of the Internet connection and service profiles in the non-volatile memory.
AT^SIPS can also be used to reset the settings to their default values without saving.
• Internet service profile settings (configured with AT^SISS) are specific to the interface. Therefore resetting,
loading or saving service profiles can be done only for the current interface.
• Internet connection profile settings (configured with AT^SICS) are interface independent. Therefore resetting,
loading or saving connection profiles will take effect on all interfaces.
Please note that each time after restart the BGS2T will automatically load the service profile(s) stored on the
ASC0 interface and the connection profiles stored on all interfaces. Service profiles stored on other interfaces
can be loaded with AT^SIPS.
Syntax
Parameter Description
Internet profile storage type parameter.
“connection“ Handle AT^SICS parameter set. Applicable to all interfaces.
“service“ Handle following AT^SISS parameters for current interface:
service type (srvType), connection id (conId), alphabet, address, TCP max
retransmission (tcpMR), overall timeout (tcpOT);
for HTTP: user, password, authentication control flag (hcAuth);
for SMTP: user, password, TCP port (tcpPort), email sender address
(smFrom), authentication control flag (smAuth);
for POP3: user, password, TCP port (tcpPort).
All other AT^SISS parameters are volatile and cannot be saved or loaded with
AT^SIPS, but reset to their default values.
“all“ Handle AT^SICS parameters AT^SISS parameters listed above.
Internet profile storage action parameter
“reset“ Reset current profile(s) for given <type> to default settings without saving.
If <ProfileId> is given only specific profile will be reset.
Test Command
AT^SIPS=?
Response(s)
^SIPS:(list of supported <type>s), (list of supported <action>s), (list of supported <ProfileId>s)
OK
Write Command
AT^SIPS=<type>, <action>[, <ProfileId>]
Response(s)
OK
ERROR
+CME ERROR: <err>
PIN ASC0 MUX1 MUX2 MUX3 Last
- + + + + - -
<type>
(str)
<action>
(str)
To Next Page
Loading...
Need help?
General
