BGS2T AT Command Set
8.3 AT^SOPS
BGS2T_ATC_V01.301 Page 180 of 554 1/31/12
c
8.3 AT^SOPS Extended Operator Selection
AT^SOPS queries the present status of the BGS2T's network registration. Since basic operator selection services
are available with AT+COPS this command uses the methods of the Enhanced Operator Name String (EONS)
specification while handling operator name strings. Additional EONS related information is available with
AT^SIND.
AT^SOPS test command lists sets of five parameters, each representing an operator present in the network.
A set consists of
1. an integer indicating the availability of the operator,
2. specification of the source of the operator name <eonsOperator>,
3. operator name according to EONS Table,
4. Service Provider Name from the SIM Service Table and
5. numeric format representation of the operator.
Any of the parameters may be unavailable and will then be an empty field (,,).
The list of operators comes in the following order: Home network, networks referenced in SIM and other net-
works.
If the test command is used during an ongoing GPRS transfer, traffic will be interrupted for up to a minute.
Syntax
Parameter Description
Status
0 unknown
1 operator available
2 current operator
3 operator forbidden
Specification of the source of the operator name <eonsOperator>. Details of EONS-supplied operator name
types are available at AT^SIND.
Operator name; format depends on the source of the operator name, specified by <eonsType>. Can be up to
24 characters long.
Test Command
AT^SOPS=?
Response(s)
^SOPS:[list of present operator(<opStatus>, <eonsType>, <eonsOperator>, <servProvider>,
<opName>)s], , (), ()
OK
ERROR
+CME ERROR: <err>
PIN ASC0 MUX1 MUX2 MUX3 Last
- + + + + - -
<opStatus>
(num)
<eonsType>
(num)
<eonsOperator>
(+CSCS)
To Next Page
Loading...
Need help?
General
