BGS2T AT Command Set
15.10 AT^SSTGI
BGS2T_ATC_V01.301 Page 436 of 554 1/31/12
c
15.10 AT^SSTGI SAT Get Information - Send SS (17)
This command shall be used after receiving the URC ^SSTN: 17
The module is sending a supplementary service request to the network, and is alerting the user of this. Text and
an icon identifier shall be passed to the TE to display to the user.
Syntax
Parameter Description
17 Proactive command ID, see Table 15.6, Command Type Table.
This byte is RFU.
String to provide the user with information.
If the string is provided by the SIM, the TE shall use it to inform the user. This is also an indication that the TE
should not give any other information to the user on the fact that the ME is sending an SS request.
If the alpha identifier is not provided by the SIM, the ME may give information to the user concerning what is
happening.
0...255 Used as bit field
bit 1 0: Icon is self explanatory and replaces text
1: Icon is not self-explanatory and shall be displayed with the text Determined
value only if associated icon ID is not 0 (an icon exists).
bit 2-8 RFU
0...255
0No Icon
Write Command
AT^SSTGI=17
Response(s)
^SSTGI: <cmdType>[, <commandDetails>][, <text>], <iconQualifier>, <iconId>
OK
ERROR
+CME ERROR: <err>
PIN ASC0 MUX1 MUX2 MUX3 Last
- + + + + - -
<cmdType>
(num)
<commandDetails>
(num)
<text>
(str)
<iconQualifier>
(num)
<iconId>
(num)
To Next Page
Loading...
Need help?
General
