BGS2T AT Command Set
7.7 ATDI
BGS2T_ATC_V01.301 Page 146 of 554 1/31/12
c
7.7 ATDI Mobile originated data call to ISDN number
Syntax
Command Description
TA attempts to set up an outgoing data call to ISDN number.
Parameter Description
ISDN number
String with maximum length of 20 characters. Allowed characters: +, 0-9, A, B, C.
Note
• This command may be aborted generally by receiving a character during execution. Abortion is not possible
during some states of connection setup such as handshaking.
Exec Command
ATDI<n>
Response(s)
If no dialtone (parameter ATX2 or ATX4):
NO DIALTONE
If busy (parameter setting ATX3 or ATX4):
BUSY
If connection cannot be set up:
NO CARRIER
NO DIALTONE
All other error reasons:
+CME ERROR: <err>
If successfully connected :
CONNECT <text>
When TA returns to command mode after call release:
OK
PIN ASC0 MUX1 MUX2 MUX3 Last Reference(s)
+ + + - - - - V.250
<n>
(str)
To Next Page
Loading...
Need help?
General
