BGS2T AT Command Set
15.9 AT^SSTGI
BGS2T_ATC_V01.301 Page 434 of 554 1/31/12
c
15.9 AT^SSTGI SAT Get Information - Set Up Call (16)
This command shall be used after receiving the URC ^SSTN: 16. If the SIM Application attempts to set up a call
it uses this response to inform the TE of the call parameters.
The sequence of events is as follows:
1. After the Remote-SAT notification 16 was issued the TE has to request the command parameter using
AT^SSTGI=16.
2. If the SIM Application does not supply a confirmation text or icon parameter, the TE gives other information to
the user, e.g. the telephone number. In this case refer to step 4.
3. If the SIM Application supplies a non empty confirmation text or icon parameter, the TE uses only these to ask
the user whether or not he wishes to set up the call.
4. If the user confirms to set up the call, AT^SSTR=16,0 shall be responded.
5. If the user denies to set up the call, AT^SSTR=16,34 shall be responded.
6. After confirmation phase the TE may present a dialing animation on the screen until a mandatory parameter
line ^SSTR: 16, <TermQualifier>, <TerminationCauseText> is issued.
7. If <TermQualifier> is not equal to 0 the call setup process has not been successfully. If <TerminationCause-
Text> is not an empty string, this text shall be shown to the user for an appropriate time, e.g. 2 seconds. The text
contains information regarding the dial termination cause, e.g. call barring through Call Control by SIM mecha-
nism. If <TerminationCauseText> is an empty string, the TE shall give an own indication to the user.
8. If <TermQualifier> is equal to 0, the call setup process has been started:
If <TerminationCauseText> is not an empty string, this text shall be used to inform the user during the call setup.
If <TerminationCauseText> is an empty string, <callSetupText> and/or <confirmationIconId> shall be
used to inform the user during call setup. However, if <callSetupText> contains no data, too, no indication
shall be shown.
9. The TE shall give the user an opportunity to end an ongoing call, set up by the Proactive Command. In this
case the TE shall issue an ATH command to the ME.
Syntax
Parameter Description
16 Proactive command ID, see Table 15.6, Command Type Table.
0 Set up call, but only if not currently busy on another call
1 Set up call, but only if not currently busy on another call, with redial
2 Set up call, putting all other calls (if any) on hold
3 Set up call, putting all other calls (if any) on hold, with redial
4 Set up call, disconnecting all other calls (if any)
Write Command
AT^SSTGI=16
Response(s)
^SSTGI: <cmdType>, <commandDetails>, <confirmationText>, <calledNumber>,
<callSetupText>, <confirmationIconQualifier>, <confirmationIconId>,
<callSetupIconQualifier>, <callSetupIconId>
OK
ERROR
+CME ERROR: <err>
PIN ASC0 MUX1 MUX2 MUX3 Last
- + + + + - -
<cmdType>
(num)
<commandDetails>
(num)
To Next Page
Loading...
Need help?
General
