BGS2T AT Command Set
12.11 AT+FDIS
BGS2T_ATC_V01.301 Page 351 of 554 1/31/12
c
12.11 AT+FDIS Query or set session parameters
This command allows the controlling application to sense and constrain the capabilities used for the current ses-
sion. It uses AT+FDIS to generate DIS or DTC messages directly, and uses AT+FDIS and received DIS mes-
sages to generate DCS messages.
Syntax
Note
• Used for Fax Class 2 only.
Test Command
AT+FDIS=?
Response(s)
(list of <vr>s), (list of <br>s), (list of <wd>s), (list of <ln>s), (list of <df>s), (list of <ec>s), (list of <bf>s),
(list of <st>s)
OK
Read Command
AT+FDIS?
Response(s)
<vr>, <br>, <wd>, <ln>, <df>, <ec>, <bf>, <st>
OK
Write Command
AT+FDIS=<vr>, <br>, <wd>, <ln>, <df>, <ec>, <bf>, <st>
Response(s)
OK
PIN ASC0 MUX1 MUX2 MUX3 Last Reference(s)
- + + - - - - EIA PN-2388
To Next Page
Loading...
