BGS2T AT Command Set
2.2 AT&V
BGS2T_ATC_V01.301 Page 34 of 554 1/31/12
c
2.2 AT&V Display current configuration
AT&V returns the current parameter setting. The configuration varies depending on whether or not PIN authen-
tication has been done and whether or not Multiplex mode is enabled (see AT+CMUX).
Syntax
Parameter Description
[0] Profile number
Notes
• The parameters of AT^SMGO can only be displayed after the SMS data from the SIM have been read success-
fully for the first time. Reading starts after successful SIM authentication has been performed, and may take
up to 30 seconds depending on the SIM used. While the read process is in progress, an attempt to read the
parameter will result in empty values.
• The parameter of AT+CSDH will only be displayed in SMS PDU mode, see AT+CMGF.
Exec Command
AT&V[<value>]
Response(s)
ACTIVE PROFILE:
... (see Section 2.2.1, AT&V responses)
OK
PIN ASC0 MUX1 MUX2 MUX3 Last Reference(s)
- + + ± ± - - V.250
<value>
(num)
To Next Page
Loading...
