BGS2T AT Command Set
15.2 Remote-SAT States
BGS2T_ATC_V01.301 Page 421 of 554 1/31/12
c
15.2 Remote-SAT States
In order to communicate with the SIM Application Toolkit it is necessary to use AT commands which are
explained in detail in the following chapters. In general, the type of AT command which should be issued depends
on the current state of the Remote-SAT interface.
The current state of Remote-SAT is determined by
1. the Remote-SAT operating mode (AR or ER mode),
2. the application running on the SIM,
3. the Customer Application (in case of ER mode only), and
4. internal actions of the ME (especially SAT and Call Control).
To Next Page
Loading...
