BGS2T AT Command Set
15.8 AT^SSTGI
BGS2T_ATC_V01.301 Page 433 of 554 1/31/12
c
15.8 AT^SSTGI SAT Get Information - Set Up Event List (5)
This command shall be used after receiving the URC ^SSTN: 5.
However, please refer to the note below.
The response informs the TE of the events that it must monitor within itself. If any of these events occur the TE
must report them to the ME.
Syntax
Parameter Description
5 Proactive command ID, see Table 15.6, Command Type Table.
This byte is RFU.
The event list tells the TE which events have to be reported to the ME via the related commands
AT^SSTR=(232, 233, 235, 236)
0...65535 Used as bit field
bit 1-4 RFU
bit 5 0: User Activity not in Event List
1: Any user activity (keyboard press) has to be signaled to the ME
bit 6 0: Idle Screen Available not in Event List
1: Any idle screen available event has to be signaled to the ME.
bit 7 RFU
bit 8 0: Language Selection not in Event List
1: Language Selection events have to be signaled to the ME.
bit 9 0: Browser Termination not in Event List
1: Browser Termination events have to be signaled to the ME
bit 10-16 RFU
Note
• It is possible to issue AT^SSTGI during states IDLE, PAC and WAIT for this proactive command without pre-
viously receiving a URC ^SSTN:<cmdType>, see AT^SSTGI.
Write Command
AT^SSTGI=5
Response(s)
^SSTGI: <cmdType>, <commandDetails>, <eventList>
OK
ERROR
+CME ERROR: <err>
PIN ASC0 MUX1 MUX2 MUX3 Last
- + + + + - -
<cmdType>
(num)
<commandDetails>
(num)
<eventList>
(num)
To Next Page
Loading...
Need help?
General
