BGS2T AT Command Set
10.13 Examples of how to Configure and Use Internet Service Profiles
BGS2T_ATC_V01.301 Page 295 of 554 1/31/12
c
10.13.18 Server Disconnects While Transparent TCP Service is in Trans-
parent Access Mode
^SISO: 3,""
^SISO: 4,""
^SISO: 5,""
^SISO: 6,""
^SISO: 7,""
^SISO: 8,""
^SISO: 9,""
OK
at^sici?
Check the state of the Internet connection profile.
^SICI: 0,0,0,"0.0.0.0"
No Internet connection profile currently used.
OK
at^siso=1
Open Transparent TCP service.
OK
^SISW: 1,1
URC indicates that Transparent TCP service is
ready.
at^sist=1
Open transparent access mode.
CONNECT
Service is ready to send or receive data.
Good Morning NO CARRIER
Server has sent data and disconnected. Client reads
data. Then client gets NO CARRIER in AT command
mode.
at^sisi=1
Check the service state of service profile 1.
^SISI: 1,6,12,0,0,0
Service is in state "Down" (6). 12 bytes received.
OK
at^siso?
Check the service state of service profile 1.
^SISO: 0,""
^SISO: 1,"Transpar-
ent",6,2,12,0,"10.10.0.200:1026","10.10.0.1
08:65532"
Service is in state "Down" (6). Socket is assigned. 6
bytes received. 12 bytes sent. Local and remote IP
address are assigned.
^SISO: 2,""
^SISO: 3,""
^SISO: 4,""
^SISO: 5,""
^SISO: 6,""
^SISO: 7,""
^SISO: 8,""
^SISO: 9,""
OK
at^sici?
Check the state of the Internet connection profile.
^SICI: 0,2,1,"10.10.0.200"
Internet connection profile is in state "Up". Local IP
address is assigned.
OK
at^sisc=1
Close the service.
OK
at^sisi=1
Check the service state of service profile 1.
^SISI: 1,2,0,0,0,0
Service profile 1 is in state "Allocated" (2).
OK
To Next Page
Loading...
