Gemalto CINTERION BGS2T - 7.20 AT+CRLP Configure RLP Parameters for Outgoing Non-Transparent Data Calls

BGS2T AT Command Set
7.20 AT+CRLP
BGS2T_ATC_V01.301 Page 159 of 554 1/31/12
c
7.20 AT+CRLP Configure RLP Parameters for Outgoing Non-Trans-
parent Data Calls
The AT+CRLP write command sets radio link protocol (RLP) parameters used when non-transparent data calls
are originated. The read command returns the current settings for the supported RLP version 0.
Syntax
Parameter Description
Interworking window size (IWF to MS)
0...61
(&F)
Mobile window size (MS to IWF)
0...61
(&F)
Acknowledgement timer (T1 in 10 ms units)
48...[78]
(&F)
...255
Re-transmission attempts N2
1...6
(&F)
...255
Test Command
AT+CRLP=?
Response(s)
+CRLP: (list of supported<iws>s), (list of supported<mws>s), (list of supported<T1>s), (list of
supported<N2>s)
OK
Read Command
AT+CRLP?
Response(s)
+CRLP: <iws>, <mws>, <T1>, <N2>
OK
Write Command
AT+CRLP=[<iws>[, <mws>[, <T1>[, <N2>]]]]
Response(s)
OK
ERROR
+CME ERROR: <err>
PIN ASC0 MUX1 MUX2 MUX3  Last Reference(s)
- + + - - - - 3GPP TS 27.007 [35]
<iws>
(num)(&W)(&V)
<mws>
(num)(&W)(&V)
<T1>
(num)(&W)(&V)
<N2>
(num)(&W)(&V)
Confidential / Released