BGS2T AT Command Set
2.7 ATZ
BGS2T_ATC_V01.301 Page 41 of 554 1/31/12
c
2.7 ATZ Restore AT Command Settings from User Defined Profile
First ATZ resets the AT command settings to their factory default values, similar to AT&F. Afterwards the AT com-
mand settings are restored from a user defined profile in non-volatile memory of BGS2T, if one was stored with
AT&W before. Any additional AT command on the same command line may be ignored. A delay of 300 ms is
required before next AT command is sent.
If a connection is in progress, it will be terminated.
Syntax
Parameter Description
[0] User Profile Number
Exec Command
ATZ[<value>]
Response(s)
OK
PIN ASC0 MUX1 MUX2 MUX3 Last Reference(s)
- + + + + - - V.250
<value>
(num)
To Next Page
Loading...
