BGS2T AT Command Set
11.20 ATH
BGS2T_ATC_V01.301 Page 334 of 554 1/31/12
c
11.20 ATH Manual rejection of a network request for PDP context acti-
vation
The V.250 ATH command may be used to deactivate all PDP contexts which are active or online on the same
interface. This command should not be used to deactivate PDP contexts during the implicit PDP context deacti-
vation procedure which is started automatically after LCP termination or by dropping the DTR line (if AT&D2 is
configured). For details refer to Section 11.5.1, Automatic deactivation of PDP context during dial-up PPP.
The ATH command may also be used to reject a network request for PDP context activation announced by the
unsolicited result codes "RING" or "+CRING: GPRS".
Syntax
Notes
• In contrast to 3GPP 27.007 it is possible to cancel a connection with ATH after a break. This is done for com-
patibility reasons due to the "dial-up network" drivers of Microsoft Windows.
• ATH is used as a standard V.250 AT command, too (see ATH for details).
• If ATH is used to reject a network request for PDP context activation, then other PDP contexts on the same
interface which are active or online will not be deactivated.
Exec Command
ATH
Response(s)
OK
PIN ASC0 MUX1 MUX2 MUX3 Last Reference(s)
+ + + ± ± - - 3GPP TS 27.007 [35]
To Next Page
Loading...
Need help?
General
