Gemalto CINTERION BGS2T - 10.5 AT^SISI Internet Service Information

BGS2T AT Command Set
10.5 AT^SISI
BGS2T_ATC_V01.301 Page 261 of 554 1/31/12
c
10.5 AT^SISI Internet Service Information
AT^SISI serves to monitor the status of Internet service profiles defined with AT^SISS.
The AT^SISI read command requests the current status of all defined Internet service profiles.
The AT^SISI write command requests the status of the specified Internet service profile. If the specified service
profile is not defined yet, "+CME ERROR" is returned.
Syntax
Test Command
AT^SISI=?
Response(s)
[^SISI:(list of defined <srvProfileId>s)]
OK
Read Command
AT^SISI?
Response(s)
If response is related to service profile(s) created / opened on this interface:
[^SISI: <srvProfileId>, <srvState>, <rxCount>, <txCount>, <ackData>, <unackData>]
[^SISI: ...]
If response is related to service profile(s) created / opened on other interface(s):
[^SISI: <srvProfileId>, <srvParmTag>value "srvType"]
[^SISI: ...]
OK
ERROR
Write Command
AT^SISI=<srvProfileId>
Response(s)
^SISI: <srvProfileId>, <srvState>, <rxCount>, <txCount>, <ackData>, <unackData>
OK
ERROR
+CME ERROR: <err>
PIN ASC0 MUX1 MUX2 MUX3  Last
- + + + + - -
Confidential / Released