BGS2T AT Command Set
11.7 AT+CGEQMIN
BGS2T_ATC_V01.301 Page 308 of 554 1/31/12
c
11.7 AT+CGEQMIN Rel. 99 Quality of Service Profile (Minimum accept-
able)
Syntax
Command Description
The test command returns values supported as a compound value.
The read command returns the current settings for each defined context.
The write command allows the TE to specify a Quality of Service Profile for the context identified by the (local)
context identification parameter <cid> which is checked by the MT against the negotiated profile returned in the
Activate/Modify PDP Context Accept message.
A special form of the write command, AT+CGEQMIN=<cid> causes the requested profile for context number
<cid> to become undefined.
On ASC0 all QoS profiles will be stored non volatile. On all other instances only the QoS settings for context 1
are stored non volatile.
Parameter Description
Parameter specifies a particular PDP context definition. The parameter is local to the TE-MT interface and is
used in other PDP context-related commands.
1...2
Test Command
AT+CGEQMIN=?
Response(s)
+CGEQMIN: <PDP_type>, (list of supported <Traffic class>s), (list of supported <Maximum bitrate
UL>s), (list of supported <Maximum bitrate DL>s), (list of supported <Guaranteed bitrate UL>s),
(list of supported <Guaranteed bitrate DL>s), (list of supported <Delivery order>s), (list of
supported <Maximum SDU size>s), (list of supported <SDU error ratio>s), (list of supported
<Residual bit error ratio>s), (list of supported <Delivery of erroneous SDUs>s), (list of
supported <Transfer delay>s), (list of supported <Traffic handling priority>s)
OK
Read Command
AT+CGEQMIN?
Response(s)
[+CGEQMIN: <cid>, <Traffic class>, <Maximum bitrate UL>, <Maximum bitrate DL>,
<Guaranteed bitrate UL>, <Guaranteed bitrate DL>, <Delivery order>, <Maximum SDU
size>, <SDU error ratio>, <Residual bit error ratio>, <Delivery of erroneous SDUs>,
<Transfer delay>, <Traffic handling priority>]
[+CGEQMIN: ...]
Write Command
AT+CGEQMIN=[<cid>[, <Traffic class>[, <Maximum bitrate UL>[, <Maximum bitrate DL>[,
<Guaranteed bitrate UL>[, <Guaranteed bitrate DL>[, <Delivery order>[, <Maximum SDU
size>[, <SDU error ratio>[, <Residual bit error ratio>[, <Delivery of erroneous
SDUs>[, <Transfer delay>[, <Traffic handling priority>]]]]]]]]]]]]]
Response(s)
OK
ERROR
+CME ERROR: <err>
PIN ASC0 MUX1 MUX2 MUX3 Last Reference(s)
+ + + + + - - 3GPP TS 27.007 [35]
<cid>
(num)
To Next Page
Loading...
Need help?
General
