BGS2T AT Command Set
11.7 AT+CGEQMIN
BGS2T_ATC_V01.301 Page 310 of 554 1/31/12
c
1yes
[2] subscribed value
This parameter indicates the maximum allowed SDU size in octets.
[0] subscribed value
10...1520 (value needs to be divisible by 10 without remainder)
1502
This parameter indicates the target value for the fraction of SDUs lost or detected as erroneous. SDU error ratio
is defined only for conforming traffic. The value is specified as "mEe". As an example a target SDU error ratio
of 5*10
-3
would be specified as "5E3" (e.g. AT+CGEQMIN=...,"5E3",...).
[“0E0“] subscribed value
“1E2“
“7E3“
“1E3“
“1E4“
“1E5“
“1E6“
“1E1“
This parameter indicates the target value for the undetected bit error ratio in the delivered SDUs. If no error
detection is requested, Residual bit error ratio indicates the bit error ratio in the delivered SDUs. The value is
specified as "mEe". As an example a target residual bit error ratio of 5*10
-3
would be specified as "5E3" (e.g.
AT+CGEQMIN=...,"5E3",...).
[“0E0“] subscribed value
“5E2“
“1E2“
“5E3“
“4E3“
“1E3“
“1E4“
“1E5“
“1E6“
“6E8“
This parameter indicates whether SDUs detected as erroneous shall be delivered or not.
0no
1yes
2 no detect
[3] subscribed value
<Maximum SDU size>
(num)
<SDU error ratio>
(str)
<Residual bit error ratio>
(str)
<Delivery of erroneous SDUs>
(num)
To Next Page
Loading...
Need help?
General
