BGS2T AT Command Set
8.16 AT^SPLR
BGS2T_ATC_V01.301 Page 205 of 554 1/31/12
c
8.16 AT^SPLR Read entry from the preferred operators list
The AT^SPLR write command returns used entries from the SIM list of preferred operators with <index>
between <index1> and <index2>. If <index2> is not given, only entry at <index1> is returned. The test com-
mand returns the whole index range supported by the SIM.
See also 3GPP TS 27.007 [35]: AT+CPOL
Syntax
Parameter Description
Location number to start reading from
Location number where to stop reading
Index range supported by the SIM card (between <index1> and <index2>)
Operator in numeric form; GSM location area identification number
Test Command
AT^SPLR=?
Response(s)
^SPLR:(list of supported <index>s)
OK
ERROR
+CME ERROR: <err>
Write Command
AT^SPLR=<index1>[, <index2>]
Response(s)
^SPLR: <index1>, <oper>
[^SPLR: <index2>, <oper>]
[^SPLR: ...]
OK
ERROR
+CME ERROR: <err>
PIN ASC0 MUX1 MUX2 MUX3 Last
+ + + + + - -
<index1>
(num)
<index2>
(num)
<index>
(num)
<oper>
(str)
To Next Page
Loading...
Need help?
General
