Gemalto CINTERION BGS2T - 14.5 AT^SCKS Query SIM and Chip Card Holder Status

BGS2T AT Command Set
14.5 AT^SCKS
BGS2T_ATC_V01.301 Page 412 of 554 1/31/12
c
14.5 AT^SCKS Query SIM and Chip Card Holder Status
This command controls the SIM connection presentation mode and queries the connection status of the SIM and
the card holder tray of the BGS2T.
Syntax
Unsolicited Result Code
^SCKS: <SimStatus>
If the SIM connection status has changed an unsolicited result code (URC) is issued.
Parameter Description
0
(&F)
Suppress unsolicited result codes
1 Output unsolicited result codes
0 Card holder tray removed or SIM connection error
1 SIM inserted (refer to note)
2 The SIM interface hardware has been deactivated (e.g. because an invalid SIM
or a SIM with unsupported electrical specifications has been detected).
The SIM interface can be reactivated only by restarting the ME, e.g. via
"AT+CFUN= n,1".
Note
• <SimStatus> reflects the status of the SIM and the card holder tray. Therefore if an empty SIM card holder
tray is inserted, two URCs will be presented, indicating the status 1 followed by 0. See example.
Test Command
AT^SCKS=?
Response(s)
^SCKS:(list of supported <mode>s)
OK
Read Command
AT^SCKS?
Response(s)
^SCKS: <mode>, <SimStatus>
OK
ERROR
+CME ERROR: <err>
Write Command
AT^SCKS=<mode>
Response(s)
OK
ERROR
+CME ERROR: <err>
PIN ASC0 MUX1 MUX2 MUX3  Last
- + + + + - -
<mode>
(num)(&W)(&V)
<SimStatus>
(num)(&V)
Confidential / Released