BGS2T AT Command Set
15.18 AT^SSTGI
BGS2T_ATC_V01.301 Page 448 of 554 1/31/12
c
15.18 AT^SSTGI SAT Get Information - Get Input (35)
This command shall be used after receiving the URC ^SSTN: 35.
The TE is asked to prompt the user for an input, of a specified length and type, e.g. digits only. Help can be
requested by the user, if available.
Syntax
Parameter Description
35 Proactive command ID, see Remote-SAT Command Types
0...255 Used as bit field
bit 1 0: Digits only (0 9, *, # and +)
1: Alphabet set
bit 2 0: SMS default alphabet (GSM character set)
1: UCS2 alphabet
bit 3 0: ME may echo user input on the display
1: User input shall not be revealed in any way (see note)
bit 4 0: User input to be in unpacked format
1: User input to be in SMS packed format
bit 5-7 RFU
bit 8 0: No help information available
1: Help information available
String as prompt for text
0...255 Minimum length of user input.
0...255 Maximum length of user input.
Write Command
AT^SSTGI=35
Response(s)
^SSTGI: <cmdType>, <commandDetails>, <text>, <responseMin>, <responseMax>[,
<defaultText>], <iconQualifier>, <iconId>
OK
ERROR
+CME ERROR: <err>
PIN ASC0 MUX1 MUX2 MUX3 Last
- + + + + - -
<cmdType>
(num)
<commandDetails>
(num)
<text>
(str)
<responseMin>
(num)
<responseMax>
(num)
To Next Page
Loading...
Need help?
General
