BGS2T AT Command Set
5.7 AT^SPWD
BGS2T_ATC_V01.301 Page 130 of 554 1/31/12
c
5.7 AT^SPWD Change Password
The AT^SPWD command provides the same functions as AT+CPWD. The major difference between both com-
mands is that, apart from the different prefixes "^SPWD" and "+CPWD", the AT^SPWD command includes addi-
tional functions dedicated to the Customer SIM Lock. Please note that this feature is only supported by
specifically pre-configured BGS2T modules and, therefore, not part of the standard "BGS2T AT Command Set".
Ordering information and a detailed description of the "Customer SIM Lock" feature can be requested from Cin-
terion Wireless Modules GmbH. All other functions and parameters of AT^SPWD are described in Section 5.6,
AT+CPWD. The AT^SPWD command is, in every respect, identical with AT+CPWD, except that the command syntax
and response prefix is "^SPWD" instead of "+CPWD".
Each password is a string of digits the length of which varies with the associated facility. The test command
returns a list of pairs which represent the available facilities and the maximum length of the associated password.
See also AT commands AT+CLCK and AT^SLCK for more detail on the various lock features.
Syntax
Note
• When changing the PIN2 (<facility>="P2") it is recommended to check the new state of PIN2 using the
AT+CPIN2 command.
Test Command
AT^SPWD=?
Response(s)
^SPWD:list of supported ( <facility>, <password length>)
OK
Write Command
AT^SPWD=<facility>, <old password>[, <new password>]
Response(s)
New password has been registered for the facility lock function.
OK
If parameter <old password> was not correct:
+CME ERROR: 16 (+CME ERROR: incorrect password)
If the password for the selected <facility> has been invalidated due to too many failed attempts:
+CME ERROR: ...
If error is related to ME functionality:
+CME ERROR: <err>
PIN ASC0 MUX1 MUX2 MUX3 Last
+ + + + + - -
To Next Page
Loading...
Need help?
General
