BGS2T AT Command Set
1.6 Supported character sets
BGS2T_ATC_V01.301 Page 24 of 554 1/31/12
c
1.6.1 GSM alphabet tables and UCS2 character values
This section provides tables for the GSM default alphabet (3GPP TS 23.038 [27]) supported by the BGS2T.
Below any GSM character find the corresponding two byte character value of the UCS2 alphabet. For details
refer to "ETSI GSM 03.38 mapping into Unicode" [11].
1) This code is an escape to the following extension of the 7 bit default alphabet table.
2) This code is not a printable character and therefore not defined for the UCS2 alphabet. It shall be treated as the accom-
panying control character.
3) See Section 1.5 for further details on using backspace and "ò" character.
Figure 1.1: Main character table of GSM 7 bit default alphabet
To Next Page
Loading...
