BGS2T AT Command Set
15.4 AT^SSTA
BGS2T_ATC_V01.301 Page 426 of 554 1/31/12
c
15.4 AT^SSTA Remote-SAT Interface Activation
AT^SSTA write command can be used to determine the Remote-SAT activation mode <mode> and, if Explicit
Response mode is enabled, to activate the Remote-SAT interface. Removing and inserting the SIM does not
affect the activation status.
SAT commands which are not using the AT interface (non-MMI related SAT commands, e.g. PROVIDE LOCAL
INFORMATION) are executed without activating Remote-SAT.
The read command can be used to request the current operating status and the used alphabet of the Remote-
SAT interface.
Syntax
Parameter Description
ME Remote-SAT interface states
0 RESET
1 OFF
2IDLE
3 PAC
4WAIT
Setting becomes effective after restarting the ME.
0
(D)
GSM character set
Input of a character requests one byte, e.g. "Y".
1 UCS2
To display the 16 bit value of characters represented in UCS2 alphabet a 4 byte
string is required, e.g. "0059" is coding the character "Y". For details please
refer to ISO/IEC 10646.
Test Command
AT^SSTA=?
Response(s)
^SSTA:(list of supported <state>s), (list of supported <Alphabet>s)
OK
Read Command
AT^SSTA?
Response(s)
^SSTA: <state>, <Alphabet>, <allowedInstance>, <SatProfile>
OK
Write Command
AT^SSTA=<mode>[, <Alphabet>]
Response(s)
OK
PIN ASC0 MUX1 MUX2 MUX3 Last
- + + + + - -
<state>
(num)
<Alphabet>
(num)(NV)
To Next Page
Loading...
Need help?
General
