BGS2T AT Command Set
15.4 AT^SSTA
BGS2T_ATC_V01.301 Page 427 of 554 1/31/12
c
Remote-SAT handling (i.e. "^SSTN" URC, AT^SSTGI and AT^SSTR sequence) is only usable via the serial
channnel on which the Explicit Response (ER) mode was activated.
To change the serial channel execute AT^SSTA=1 on the desired channel and perform a restart.
0 SAT is already used on another instance (logical channel in case of the multi-
plex protocol).
1 SAT may be started on this instance via the write version of this command.
SAT Terminal Profile according to 3GPP TS 11.14 [15].
The profile tells the SIM Application which features (e.g. Proactive Commands) are supported by the SIM Appli-
cation Toolkit implementation of the ME.
Select Remote-SAT activation mode.
Setting becomes effective after restarting the ME. Removing and inserting the SIM does not affect the activation
status.
0
(D)
Automatic Response (AR) mode.
All commands and responses are exchanged automatically between the ME
and the SIM application. This eliminates the need to enter any Remote-SAT
commands including the AT^SSTA command.
If AR mode is enabled the ME enters the OFF state (<state>=1) after restart.
1 Explicit Response (ER) mode.
This mode is intended for use with an MMI. If ER mode is enabled the MMI is
required to handle, via ME's Remote-SAT interface, all commands and
responses transmitted to or from the SIM or USIM.
If ER mode is enabled the ME enters the IDLE state (<state>=2) after reboot.
<allowedInstance>
(num)
<SatProfile>
(str)
<mode>
(num)(NV)
To Next Page
Loading...
Need help?
General
